1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
|
[\<- Latches](12.md)
---
# Flip-flops
## Motivation for flip-flops
### Counting
- A common example of a sequential circuit
- We'll learn later how this really works
### Time, and gate delays
- All the timing diagrams we have seen show the output change as soon as the inputs change
- Not reality but often a fine abstraction when we only care about logical behavior
- In reality, it takes some amount of time for a change in an input to "propagate" to a change in the output
- This form of propagation delay is called gate delay
### Pass-thru effects
- With a latch, the output can change for the entire time the CLK is asserted
- What happens if next count logic is "faster" than the time CLK is high?
- Uneven counting, probably not what we want
### Avoiding pass-thru effects
- We could shrink the time that CLK is high, but this becomes impractical
- Circuitry to generate and distribute CLK is cleaner if high and low phases are equal
- Use circuit structures that are designed to react to just the "edge" of the clock
- Output can only change when CLK goes from low to high (rising edge) or high to low (falling edge)
- We call these circuits flip-flops
---
## Master/slave latch
- Note how the clock "port" is drawn
- The output Q can only change at the "edge" of the clock (the negative edge)
---
## Positive edge-triggered flip-flop
- A more efficient design than master/slave
### How does it work?
- When clock is low
- P1 and P2 are high, isolating Q/!Q
- P3 is the same as D and P4 is !D
- As soon as Clock goes high
- If P3 is high (i.e., D is 1)
- P1 goes low, setting Q to 1
- Gates 1 and 3 are disabled, P4 doesn't matter
- If P4 is high (i.e., D is 0)
- P2 goes low, resetting Q to 0
- Gate 4 is disabled, D doesn't matter
- When Clock goes low, P1 and P2 go to 1
---
## Summary of latch/flip-flop behavior
### Latch vs flip-flops
### Analogies
- A latch is like a door:
- When CLK is high, the door is open
- Q does whatever D does while the door is open
- When CLK goes low, the door shuts
- Q "latches" onto whatever value was on D when the door shut
- A flip-flop is like a camera
- Q is a picture of whatever is on D at the relevant edge (positive edge or negative edge)
- Q \*cannot\* change until the next relevant edge
### Setup and Hold Time
- The output "latches" when the CLK transitions (waveform is neg-edge trigger)
- If D changes close to this time, you might not get a stable output
- Like taking a picture and the subject moves
|
